Submit assignment1

[Tippa Wongstitwilairoong]

Dear Aj,

I attempted to submit Assignment 1 in ZIP file format, but unfortunately, it seems that the submission is either not possible or restricted until June 26, 2023.
Kindly let me know if there are any alternative submission methods or if I should proceed with submitting it on the specified date.

Best regards,

[Tippa Wongstitwilairoong]

In order to resolve this issue, I made some adjustments to my submission. I removed the base folder, which included the Raster folder, table folder, temple folder, and vector folder in project folder. Instead, I submitted only the files “Tippa_week1_Assignment.doc” and “Westernmalaria_Tippa_practical_1.qgis.” This modification led to a smaller ZIP file size. I can confirm that the submission process has been successfully completed.

[Zarni Lynn Kyaw]

When I try to submit the ZIP file it went well. Just a friendly reminder, the site only accept a certain kind of file format for submission.

[Petcharat Chompo]

I faced the same problem as other participants. The assignment file was attached, but there was no response from the system. Please inform us of the next step we should take.

[Tippa Wongstitwilairoong]

Dear Petcharat,
I encountered a similar problem as you did. However, I managed to resolve it by sending a ZIP file containing only two specific files: “Tippa_week1_Assignment.doc” and “Westernmalaria_Tippa_practical_1.qgis” within the “Tippa_week1_projectfile” folder. I made sure to remove all other files such as the Raster folder, table folder, temple folder, and vector folder from the project file before submitting it. This approach seemed to work, and I believe the issue may have been related to the large size of the initial submission with all the additional folders. I suggest you try the same method, as it might work for you as well.

Tippa

[Jatuporn Limtrakul]

Hi All,

The assignment 1.3 asked to set the precision of population layer to
“Precision 0” (to remove decimals). But when I select precision 0, the value shows 2 decimals, to remove decimals need to select precision -2.

Also when I close and open the project file again it go back to default “precision 4”.

Is anyone experiencing the same problem?

[Patiwat Sa-angchai]

For uploading project file
To send the project all you need is to send .QGZ of your project within the zip file. The rest of component we will connect it to our file to preview your result compare with your screenshot, no need for all of the raw data you downloaded.

For precision of population layer
This precision number use to show the precision value in your legend showing up in the Layer panel. This setting in poulation layer it will show no difference because the population data is in integer format. if you set it to minus it will showing the round-up value for you in your legend.

[Author]

Posts